RPV Reports / Home
 
Search in RpvSoftware.com
Go!

What Rpv is

Rpv Reports 2024

Downloads

Support

Buy now!

Contact us

 
Rpv Reports help>

"\N" command. (One line down).
"\N" command is used to begin a new line. It goes down as many as specified in SPACING parameter by default. If SPACING setting was not set, default value for it is 200.

There are some important things to know about this command:

"\N" is absolutelly necessary at the end of the line.
Forgetting or ommiting this command will cause that all the text is in the same line.

Each "\N" command goes down the equivalent of the SPACING command.
This means that by default an "\N"
command will go down 200 twips.

Example:

{$column_1} Text column 1/1
{$column_2} Text column 2/2 {\n}
{$column_1} Text column 1/2{$column_2} Text column 2/2 {\n}

There is an alternative not to repeat the "\N" command until we reach the place we need. For example if we want to go down 4000 twips, we would have to execute 20 "\N"commands like this:

{\n;\n;\n;\n;\n;\n;\n;\n;\n;\n;\n;\n;\n;\n;\n;\n;\n;\n;\n;\n}

Instead, specify the SPACING like this.

{spacing=4000;\n}

In this case, the "\N" command will go 4000 twips down instead of 200. Spacing will be 200 again automatically after the "\N" command.

See also:

Spacing command
Spacing parameter
\P command


Home
What Rpv is
Rpv Reports 2024

Products
Rpv Reports 2024
Personalized edition

More...
Downloads
Support
Rpv Reports Online help
Rpv Visual Editor online help
Examples
/temp section
Videos




Copyright (c) 2001-2024 - Rpv Software. All rights reserved.